HYDRAULIC BRAKE
INSTALLATION
Install the brake hose and seal washer.
TORQUE: 25-35 N.m (2.5-3.5 kg-m,
18-25 ft-lb)
Install the bracket to the caliper.
Install and tighten the caliper bracket to the front
fork to the specified torque.
TORQUE: 24-30 N.m (2.4-3.0 kg-m,
17-22 ft-lb)
Tighten the pin bolts arid install the pin bolt caps.
TORQUE: 15-20 N.m (1.5-2.0 kg-m,
11-14 ft-lb)
After the front brake has been installed, bleed air
from the system (Page 12-3).
BRAKE MASTER CYLINDER
REMOVAL
Drain brake fluid from the bleeder valve by operat
ing the brake lever.
Remove the brake lever, front stoplight switch, rear
view mirror and brake hose.
Remove the master cylinder from the handlebar.
DISASSEMBLY
Remove the reservoir cap and diaphragm.
Remove the boot.
Remove the snap ring.
Remove the master cylinder piston and spring.
12-9
(1) PIN BOLTS
(1) MASTER CYLINDER
(1) BOOT
�HONDA
� MBXSO· MBXSO
(2) SNAP RING PLIERS
07914-3230001
'
Summary of Contents for MBX50
