�HONDA
� MBX50· MBXSO
STEERING STEM INSTALLATION
(1) STEELBALLS(21)�
(2) BOTTOM CONE RACE�
(3) DUST SEAL�
(4) DUST WASHER�
Drive the top and bootom ball races into the head
pipe with the same tool.
I nstal I the washer and dust seal.
Grease the ball race, steel balls and cone race.
Install the steering stem.
Install the bearing adjustment nut in the frame neck
and tighten it until snug against the top cone race,
then back it out 1 /8 turn.
Check that the stem rotates freely.
FRONT WHEEL/SUSPENSION
�(6)
�(7)
�(8)
(9)
BEARING ADJUSTMENT NUT
TOP CONE RACE
STEEL BALLS (21)
TOP BALL RACE
�- (10) BOTTOM BALL RACE
(1) BALL RACE REMOVER
07944-1150001
(1) BEARING ADJUSTMENT
NUT
(2) PIN SPANNER
11-20
Summary of Contents for MBX50
