Honda automobile, Owner'S Manual

Page: 178 / 353

If your vehicle’s battery is
disconnected or goes dead, you may
need to set the clock.
Press the CLOCK button. The
displayed time begins to blink.
Change the hours by pressing the H
(Preset 1) button. Change the
minutes by pressing the M (Preset
2) button.
The display shows the time when the
ignition switch is in the
ACCESSORY (I) or the ON (II)
position. The Navigation System
receives signals from the Global
Positioning System (GPS), and the
displayed time is updated
automatically by the GPS. Refer to
the Navigation System Owner’s
Manual to set up the time.
You can switch the clock display to
either the 12-hour system or 24-hour
system. To switch the display, press
the PWR/VOL knob for more than 2
seconds with the audio system on,
and press the TUNE knob until
‘‘CLK’’ is displayed on the display.
Turn the TUNE knob left (12-hour)
or right (24-hour), and then push the
PWR/VOL knob.
Press the CLOCK button again to
enter the set time.
You can quickly set the time to the
nearest hour.
If the displayed time is before the
half hour, press the CLOCK button,
then press the R (Preset 3) button to
set the clock back to the previous
hour. If the displayed time is after
the half hour, the clock sets forward
to the beginning of the next hour.
For example: 1:06 will reset to 1:00
1:53 will reset to 2:00
All types
On A and B types
On C type
Setting the Clock
Features
175
06/10/30 17:05:14 32SJD620_178