Holiday Savoy LX 2006, Manual

Page: 87 / 154

Savoy SL & LX 5th Wheel & Travel Trailer 2006 Appliances — Section 4 • 87
• The cycle Status lights indicate operation being performed within the cycle.
• When the cycle is complete, all Cycle Status lights will be OFF.
NOTE:
To change a cycle selection after the cycle has started, turn the Cycle Control knob to OFF.
Select a new cycle.
Stopping/Restarting the Washer:
• To pause the washer at any time, push the START/PAUSE button. The Cycle Status lights will flash while
the washer cycle is paused. If left in pause, the cycle will terminate after two hours.
• To restart the washer, close the lid (if necessary) and push the START/PAUSE button.
• To cancel cycle, turn CYCLE SELECTOR knob to OFF . Cycle status lights will turn OFF .
NOTE:
When lid is opened during a cycle, all machine operation will stop. Cycle will resume when
lid is closed.
WARNING:
Do not wash or dry articles that have previously been cleaned, washed, soaked or spotted
with gasoline, dry cleaning solvents or other flammable or explosive substances. They emit
vapors that could ignite or explode. Do not add gasoline, dry cleaning solvents or other
flammable or explosive substances to the wash water.
CAUTION:
Do not use the washer while traveling. Suspension movement, combined with the weight of
the drum while in the wash cycle, can damage internal Washer components.
Winterizing the Clothes Washer
To winterize your washer follow the instructions below to avoid damage to your unit due to freezing:
1. Run the washer in a spin cycle to remove the majority of the water from the washer/dryer.
2. Close the hot and cold water supply valves on the inlet hoses located behind washer/dryer. Remove the
hoses from the valves and allow them to drain. Leave the hoses disconnected during storage.
3. Unplug the power cord.
4. Wipe the inside of the washer with a clean dry cloth.
To place washer back into service:
1. Plug power cord into receptacle.
2. Connect the two inlet water supply hoses to the water supply valves. Red line for hot water and blue line
for cold water.
3. Open water supply valves and operate washer for one complete cycle and check for leaks.
NOTE:
When placing the unit back into service, allow the unit to operate for one complete cycle
before doing laundry.