Holden Equinox Owner Manual (Holden-Localizing-Holden-12561772) -
2019 - crc - 6/26/18
294
Vehicle Care
19. Return the air only hose (10)
and power plug (9) back to
their original storage location.
20. If the flat tyre was able to
inflate to the recommended
inflation pressure, remove the
maximum speed label from the
sealant canister and place it in
a highly visible location.
Do not exceed the speed on
this label until the damaged
tyre is repaired or replaced.
21. Return the equipment to its
original storage location in the
vehicle.
22. Immediately drive the vehicle
8 km (5 mi) to distribute the
sealant in the tyre.
23. Stop at a safe location and
check the tyre pressure. Refer
to Steps 1
–
10 under
“
Using the
Tyre Sealant and Compressor
Kit without Sealant to Inflate a
Tyre (Not Punctured).
”
If the tyre pressure has fallen
more than 68 kPa (10 psi)
below the recommended
inflation pressure, stop driving
the vehicle. The tyre is too
severely damaged and the tyre
sealant cannot seal the tyre.
If the tyre pressure has not
dropped more than 68 kPa
(10 psi) from the recommended
inflation pressure, inflate the
tyre to the recommended
inflation pressure.
24. Wipe off any sealant from the
wheel, tyre, or vehicle.
25. Dispose of the used tyre
sealant canister (4) at a local
dealer or in accordance with
local state codes and practices.
26. Replace it with a new canister
available from your dealer.
27. After temporarily sealing a tyre
using the tyre sealant and
compressor kit, take the
vehicle to an authorised dealer
within 161 km (100 mi) of
driving to have the tyre
repaired or replaced.
Using the Tyre Sealant and
Compressor Kit without
Sealant to Inflate a Tyre (Not
Punctured)
The kit includes:
1. Sealant Canister Inlet Valve
2. Sealant/Air Hose
3. Base of Sealant Canister
4. Tyre Sealant Canister
5. On/Off Button
