Holden Trailblazer Owner Manual (GMSA-Localizing-Australia - 10460368) -
2017 - crc - 6/29/16
234
Vehicle Care
Adding Coolant
Caution
If the coolant level is too low,
engine damage may occur.
Do not spill coolant on the
vehicle's exterior surfaces as it
can damage the paintwork. If you
do, wash it off immediately.
Note
Use only approved coolant. See
Recommended Fluids and
Lubricants
1. Turn the ignition off.
2. Remove the coolant
reservoir cap.
3. Add the required amount of
coolant.
4. Replace the cap securely.
If the coolant requires regular
topping up, contact a Holden
Dealer.
{
Warning
Avoid repeated or prolonged
contact with coolant.
Wash off with soap and water.
Keep out of reach of children.
If the coolant level is low, there may
be a leak in the cooling system:
1. Look for leaks at the radiator
hoses and connections, heater
hoses and connections,
radiator and water pump.
Take care when checking these
areas as they may still be hot.
2. If a major leak or other
problems are found, do not run
the engine until all problems
have been repaired. Contact a
Holden Dealer.
3. If no problems are found, refill
the coolant reservoir. See
Adding Coolant previously in
this section.
{
Warning
Do not remove the radiator cap if
the engine and radiator are still
hot. Scalding fluid and steam can
be blown out under pressure
which could cause serious burns.
Washer Fluid
Check the fluid level weekly.
Adding Washer Fluid
1. Lift the front of the cap up.
