Holden Trailblazer Owner Manual (GMSA-Localizing-Australia - 10460368) -
2017 - crc - 6/29/16
198
Driving and Operating
and/or moving faster than 5 km/h,
the two-wheel high or four-wheel
high indicator light will flash for
30 seconds but will not complete the
shift and the light will go back to the
original setting.
Shifting to Neutral (2
m
, 4
m
or 4
n
to Neutral)
Use N (Neutral) when you plan to
tow the vehicle. See
for towing
instructions. The vehicle must be
stopped. To shift the transfer case
into N (Neutral) with the key on
position
ON
, do the following:
1. Set the parking brake.
2. Press the brake pedal and shift
the transmission in N (Neutral).
3. Shift the transfer case to
two-wheel high
2
m
.
4. Rotate the shift control switch
clockwise past four-wheel low
4
n
to N (Neutral). Hold the
switch in the N (Neutral) setting
for at least 20 seconds or wait
until the red Neutral indicator
light stops flashing and stays
on. The N (Neutral) red
indicator light will come on
when the transfer case shift to
N (Neutral) is complete.
Note
Upon releasing the shift control
switch from N (Neutral) setting, the
switch will rotate to the four-wheel
low (
4
n
) setting. The transfer case
will remain in N with red N (Neutral)
indicator light illuminated until a new
setting is selected.
5. Press and hold the brake pedal
and shift the transmission to
R (Reverse) for 1 second, then
shift the transmission to D
(Drive) for 1 second to insure
the transfer case is in
N (Neutral). If the transfer case
is not in N (Neutral), repeat this
procedure starting at Step 3.
6. Place the transmission selector
lever in P (Park).
7. Turn the ignition to LOCK/OFF.
This N (Neutral) setting is a
four-wheel drive neutral, meaning
the front and rear outputs of the
transfer case are disengaged as in
four-wheel high. With a disengaged
transfer, there is no power flow the
either axle, thus allowing towing
without the driveline binding.
Shifting Out of Neutral
After towing the vehicle, you will
have to shift out of N (Neutral) in
order to drive. To shift out of
N (Neutral), do the following:
1. Set the parking brake and
apply the brake pedal;
2. Shift the transmission to
N (Neutral) position;
3. Start the vehicle or keep the
engine off and turn the key to
the ACC/ACCESSORY
position;
4. Rotate the transfer case shift
control switch from the
four-wheel low
4
n
setting to the
desired setting;
5. Release the parking brake.
