Holden Trailblazer Owner Manual (GMSA-Localizing-Australia - 10460368) -
2017 - crc - 6/29/16
Keys, Doors, and Windows
19
/
(Remote Vehicle Start) :
This
button will be on the RKE
transmitter if the vehicle has remote
start.
The climate control system will use
the previous settings during a
remote start. The rear defog may
come on during remote start based
on cold ambient conditions.
Other conditions can affect the
performance of the transmitter. See
Starting the Vehicle
To start the engine using the remote
start feature:
1. Aim the RKE transmitter at the
vehicle.
2. Press and release
Q
.
3. Immediately after completing
Step 2, press and hold
/
for at
least four seconds or until the
turn signal lamps flash. The
turn signal lamps flashing
confirms the request to remote
start the vehicle has been
received.
When the engine starts, the park
lamps will turn on and remain on as
long as the engine is running. The
doors will be locked and the climate
control system may come on.
The engine will continue to run for
10 minutes. Repeat the steps for a
10-minute time extension. Remote
start can be extended only once.
If the engine is running when you
enter the vehicle, turn the ignition
switch ON. If the engine is not
running when you enter the vehicle,
start the engine normally.
Extending Engine Run Time
For a 10-minute extension, repeat
Steps 1
–
3 while the engine is still
running. The remote start can be
extended once.
When the remote start is extended,
the second 10 minutes will start
immediately.
For example, if the engine has been
running for five minutes, and
10 minutes are added, the engine
will run for a total of 15 minutes.
A maximum of two remote starts,
or a single start with an extension,
is allowed between ignition cycles.
The vehicle's ignition must be
turned on and then back off before
the remote start procedure can be
used again.
Cancelling a Remote Start
To cancel a remote start, do one of
the following:
.
Aim the RKE transmitter at the
vehicle and press and hold
/
until the park lamps turn off.
.
Turn on the hazard warning
flashers.
.
Turn the vehicle on and then off.
Conditions in Which Remote Start
Will Not Work
The remote vehicle start feature will
not operate if:
.
The key is in the ignition.
.
The bonnet is not closed.
.
The hazard warning flashers
are on.
