Hitachi RAS-(2-6)HVNP1(E), Service Manual

Page: 110 / 498

3 Piping work and
refrigerant charge
96
SMGB0087 rev.0 - 12/2013
3.7 Drain piping
3.7.1 Drain discharging boss
When the base of the outdoor unit is temporarily utilized as a drain receiver and the drain water in it is discharged, this drain
boss is utilized to connect the drain piping.
Model Applicable Model
DBS-12L
RAS-(2/2.5)HVNP1
RAS-3HVNC1
DBS-26
RAS-3HVNP1E
RAS-(4-6)H(V)N(P/C)1E
RAS-(8-10)HN(P/C)E
RAS-12HN(P/C)

Connecting procedure
1
Insert the plastic cap into the drain boss up to the extruded portions.
2
Insert the boss into the unit base up to the extruded portions.
3 Size of the drain boss is:
- For DBS-12L: 15 mm (O.D.)
- For DBS-26: 32 mm (O.D.)
4 A drain pipe should be field-supplied.
N O T E
• Do not use this drain boss set in a cold area, because the drain water may freeze.
• This drain boss is not sufficient to collect all the drain water. If collecting drain water is completely required, provide a
drain-pan that is bigger than the unit base and install it under the unit with drainage.
RAS-(2-2.5)HVNP / RAS-3HVNC
RAS-3HVNPE / RAS-(4-6)H(V)N(P/C)E /
RAS-(8-10)HN(P/C)E / RAS-12HN(P/C)
Drain pipe
Plastic cap
Plastic cap
Drain hole
100 mm
Plastic cap
Drain hole
Push Push
≥ O.D. ∅ 16 mm
Rubber cap
Drain boss
Extruded portion
Drain pipe
Drain pipe
Drain hole
of base