Hitachi HRNM/FSN(2)(M)(E), Installation And Operation Manual

Page: 21 / 393

23
PMML0129A rev.4 - 02/2010
ENGLISH
■
Defining the schedule to be applied
1. Hold down the TIMER switch for more than 3 seconds and the SET indicator appears. All the
days and schedule numbers are indicated.
:
SET Mon Tue Wed Thu Fri Sat
Sun 1234S
ON
OFF
:
2. Press

DAY switch until the day to be set flickers.
By pressing it, the day flickers
[Mon]→[Tue] →… → [Sun]→[Mon~Sun]→[Mon~Fri]→[Sat, Sun]→[Mon]…
In case of flickering various days, the same setting is applied to the days.
:
SET Mon Tue Wed Thu Fri Sat
Sun
1234S
ON
OFF
:
3. Press the SCHEDULE

switch until the schedule number you wish to set blinks.
:
SET Mon Tue Wed Thu Fri Sat
Sun
1234S
SCHEDULE
ON
OFF
:
4. Press the switch, and the SCHEDULE indication appears. Then the schedule number indicated
in step 3 is applied to the days set in step 2. Press the OK switch to activate or deactivate the
schedule. If the schedule is activated, the word SCHEDULE is lit up.
:
Mon
NEXT SCHEDULE
OFF
:
5. Press the TIMER switch and the SET indicator goes out, and the mode returns to normal.
:
Mon 1234S
NEXT SCHEDULE
ON
:
■
Cancelling the timer
In normal mode, press SELECT
 
switch simultaneously more than 3 seconds. The NEXT
SCHEDULE indicator blinks. (Cancellation of all the timer)
:
Mon 1234S
NEXT SCHEDULE
ON
:
During the TIMER cancellation mode, press SELECT
 
switch simultaneously more than 3
seconds. NEXT SCHEDULE is indicated. (Timer activation)
:
Mon
1234S
NEXT SCHEDULE
ON
:
■
Setting the temperature shifts (energy saving mode)
1. Perform the ON/OFF time setting operation of sub-chapter point 1 and 2, and then select “S” as
a schedule number
:
1234S
SCHEDULE
ON
OFF
:
SET
2. Set the ON/OFF operation in steps 4,5 and 6 of the “Setting the timer” section, and set the ON/
OFF time. The temperature setting is then indicated.
:
1234S
SCHEDULE
ON
OFF
:
SET
3. Select the temperature to shift by
 
switch. “3” or “5” can be selected. In this time, if reset
switch is pressed, shift temperature is not performed indicating “- -“. When the TIMER switch is
pressed, the temperature is indicated and the mode changes to schedule number selection.
:
1234S
SCHEDULE
ON
OFF
SET
:
4. When the TIMER switch is pressed, the SET and SCHEDULE indicators go out and the mode
returns to normal
:
S
NEXT SCHEDULE
OFF
:
Mon

NOTE:
1. When this operation is performed, the temperature shift indicator changes.
2. When this operation is performed, the temperature setting of the CS-NET or PSC-5S has a normal range, while the remote
control setting may be changed to a new range.
3. The increase or decrease in the temperature setting during the scheduled time (±3 ºC or ±5 ºC) varies according to the ope-
ration mode.
- If the system is operating in FAN, COOL or DRY mode, the temperature variation is +.
- If the system is operating in HEAT, mode, the temperature variation is -.
REMOTE CONTROLLER
OPERATION