General Dynamics Itronix | 72-0137-003
GD8000 User Guide
GD8000 User Guide
GD8000 User Guide
Customizing Your BIOS
The Security Menu
Field
Setting
Description
Change Supervisor
Password
Enter New Password
Install or Change the Supervisor password. This field must be set before a
user level password can be set. You will be prompted to set and then verify a
new password. Type in six or fewer keystrokes. If you make an error, press
ESC
to start over.
Change User Password Enter New Password
Install or Change the User password.
Clear User Password
Clear User Password?
Ok
Cancel
Immediately clears the User password. This option is only available when a
user password has been set.
Password Check
Setup
Always
This option is only available when a password has been set.
Setup: requires a password when entering the setup utility.
Always: requires a password during boot and when entering the setup utility.
CAUTION
Incorrect settings can cause your system to malfunction. To correct mistakes, return to Setup and restore the Setup
Defaults by pressing
F9
.
The Exit Menu
You use the exit menu to leave the BIOS Setup Utility.
Field
Setting
Description
Save Changes and Exit
O
k
Cancel
Exit system setup after saving the changes. The
F10
key can be used for
this operation.
Discard Changes and Exit
O
k
Cancel
Exit system setup without saving any changes. The
ESC
key can be
used for this operation.
Discard Changes
O
k
Cancel
Discards changes done so far to any of the setup questions. The
F7
key
can be used for this operation.
Load Optimal Defaults
O
k
Cancel
Load Optimal Default values for all the setup questions. The
F9
key can
be used for this operation.