Hioki SW9001, Instruction Manual

Page: 66 / 170

62
LAN Interface
Setting LAN communications
Set the commands shown below for the LAN communications.
:SYSTem:COMMunicate:LAN:IPADdress <Value 1>,<Value 2>,<Value 3>,<Value 4>
Set the IP address for the device.
:SYSTem:COMMunicate:LAN:SMASK <Value 1>,<Value 2>,<Value 3>,<Value 4>
Set the LAN subnet mask.
:SYSTem:COMMunicate:LAN:GATeway <Value 1>,<Value 2>,<Value 3>,<Value 4>
Set the address for the default gateway.
:SYSTem:COMMunicate:LAN:CONTrol <1 - 9999>
Specify the communication command port No.
:SYSTem:COMMunicate:LAN:UPDate
Update and apply the LAN settings.
When the communication setting mode switch ( DFLT / USER ) is set to DFLT , the default settings are
used regardless of the settings specified here.
Reference: "2.6 Setting the Communication Setting Mode" (p. 22)
Setting items
IP address An address to identify individual instruments that are connected on the network. Be
sure to set an address that does not overlap with other devices.
Subnet mask This setting divides the IP address into the address part showing the network and
the address part showing the device. Be sure to set a subnet mask that matches
the subnets of other devices within the same network.
Gateway
IP address
For network connection
When the communication PC and the device are in different networks, specify the
IP address of the device that becomes a gateway.
If the PC is in the same network, set a gateway address that is the same as the
default gateway in the general PC settings.
For one-to-one connection between the device and PC or when no gateway
is used
Set the IP address to 0.0.0.0 .
Communication
command port No.
Specify the TCP/IP port No. used for connecting communication commands.
HIOKI SW1001A961-04