Hioki SW9001, Instruction Manual

Page: 26 / 170

22
Setting the Communication Setting Mode
2.6 Setting the Communication Setting Mode
The device uses the communications interface for control.
You can select the fixed setting mode for initial communication settings or the user setting mode for
user settings using the switch on the rear of the device.
Specify the communication settings according to the interface to be used in the user setting mode.
Reference: “8.1 Interface Overview and Features” (p. 59)
Rear
1
2
1
Check that the power switch is
off ( ).
2
Change the communication
setting mode using the
communication setting mode
switch.
Switch
Communication
setting mode
Device setting description
DFLT
Fixed setting mode All of USB, RS-232C, and LAN can be used.
Communications are performed using the specified communication
settings.
•USB
No setting item
•RS-232C
Transmission speed: 9600 bps, data bits: 8; stop bit: 1; parity
check: none; flow control: none
•LAN
IP address: 192.168.0.254
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0 (None)
Communication command port number: 23
USER User setting mode All of USB, RS-232C, and LAN can be used.
Use the communication settings that are specified using the following
communication commands.
•USB
No setting item
•RS-232C
:SYSTem:COMMunicate:RS232C:SPEED <
Transmission speed
>
Reference: “(8) RS-232C settings” (p. 103)
•LAN
:SYSTem:COMMunicate:LAN:IPADdress <
IP address
>
:SYSTem:COMMunicate:LAN:SMASk <
Subnet mask
>
:SYSTem:COMMunicate:LAN:GATeway <
Gateway address
>
:SYSTem:COMMunicate:LAN:CONTrol <
Port No.
>
:SYSTem:COMMunicate:LAN:UPDate
Reference: “(9) LAN settings” (p. 103)
HIOKI SW1001A961-04