Hioki SW9001, Instruction Manual

Page: 129 / 170

125
10
Maintenance and Service
10.1 Troubleshooting
If damage is suspected, check “Before sending the device for repair” before contacting your
authorized Hioki distributor or reseller.
Before sending the device for repair
Symptom Check item or cause Solution Reference
No input
to the
instrument.
The power is not turned on. Check the power cord and turn on the power
switch.
p. 23
The measurement cable
for the measuring object is
disconnected.
Connect the measurement cable to each module.
Check that the measurement cable is connected
to the measuring object.
p. 18
The connection cable for the
instrument is disconnected.
Check the connection cable between the device
and instrument.
p. 19
The module connection
method is set incorrectly.
Check the terminal to be connected to the
instrument and select the correct connection
method.
p. 19
p. 28
Communications or control
cannot be performed (the
REMOTE lamp is not lit).
Check that the communication cable is connected.
Check the LAN settings.
Disconnect the USB cable and connect it to the
PC again.
Use the RS-232C cross cable.
p. 22
p. 61
p. 65
p. 66
The channel
cannot be
switched.
The module connection
method is set incorrectly.
Check the terminal to be connected to the
instrument and select the correct connection
method.
p. 28
Scanning
cannot be
performed.
The scan list is not
specified.
Specify and set the scan list.
p. 40
The EXT. I/O connection is
incorrect.
Check the EXT. I/O connection.
p. 51
10 Maintenance and Service
10
Maintenance and Service
HIOKI SW1001A961-04