Hioki PW3336-01, Instruction Manual

Page: 50 / 206

3.2 Configuring Settings
44
This section describes how to select the information shown on the instrument’s display.
• Selecting display parameters
• Selecting display channels
• Selecting rectifiers
See:
"Appendix 1 Detailed Specifications of Measurement Items (Display Items)" (p. A1)
Default settings
: Voltage (V), CH1, AC+DC
: Current (A), CH1, AC+DC
: Active power (W), CH1, AC+DC
: Power factor (PF), CH1, AC+DC
Selecting display parameters
This section describes how to select the parameters that are shown on the instrument’s display.
3.2.3 Selecting Display Content
• The voltage and current are displayed from 0.5% to 140% of the range.
(When input is less than 0.5% of the range, zero-suppression forces a value of zero to be displayed.)
• Active power is displayed from 0% to 196% of the range.
(There is no zero-suppression function.)
• Some display parameters do not have measured values depending on the rectifier and wiring mode. In
this case, the display will show [ - - - - - ].
See:
"Appendix 1 Detailed Specifications of Measurement Items (Display Items)" (p. A1)
Every time , , , or is
pressed, the each relevant display is
switched in the following order.
V
→
A
→
W
→
VA
→
Vpk
→
Apk
→
VHz
→
AHz
→
var
→
Ah+
→
Ah-
→
Ah
→
Wh+
→
Wh-
→
Wh
→
°
→
PF
→
THD-V
→
THD-A
→
θ
-V
→
θ
-A
→
η
1
→
η
2
→
T.AV-A
→
T.AV-W
→
RF-V
→
RF-A
→
CF-
V
→
CF-A
→
TIME
⋅⋅⋅
In the shift state, the display parameters cycle through the
values in reverse order. The shift state is canceled approx.
2 seconds after , , , or is released.