Hino 600, Workshop Manual, Page: 71 / 451

CLUTCH MAIN UNIT (EATON 1401) CL02–24
LUBRICATION (EATON SAS1401 and SOLO1401)
1. RELEASE BEARING
(1) The cast iron bearing housing will be equipped with either a standard
grease fitting or a lube tube extension. If a lube tube is not present, it
is necessary to remove the inspection cover to gain access to the
grease fitting. Apply grease until it purges from the rear of the hous-
ing.
2. RELEASE BEARING WEAR PADS
(1) Where the release fork contacts the bearing housing; there are small
hardened steel pads. Apply a small amount of grease to the wear
pads where the clutch release fork contacts.
3. CROSS-SHAFT BUSHINGS
(1) Lubricate both the left and the right cross-shaft bushings.
4. PILOT BEARING
(1) The pilot bearing inside the flywheel is a sealed for life bearing and
requires no lubrication.
RECOMMENDED LUBRICATION
Use a lithium soap base E.P. (Extreme Pressure) grease with a minimum of
+325 degree F operating range. It must meet the N.L.G.I.'s Grade 2 or 3
specs.
! CAUTION
Incorrect grease and improper lube procedures will cause bearing
failures, bushing wearout, yoke tip and bearing wear pad wear.
Recommended Lubrication
Supplier Product Supplier Product
American Oil Co. Amoco Uthium-M.P. Grease Texaco Multifak #2
City Service Co. Citgo Premium Lithium Grease #2 Shell Oil Co. Retinax A
Fiske Refining Co. Lubriplate 630-2 Shell Oil Co. Aivania #2
Keystone Lubricating Co. #81 Ught *Chevron Oil Co. S.R.I. 1~
Mobil Mobilgrease M.P. *Texaco Premium RB
Humble Oil Co. Udok 2 *Exxon Unirex N3
Atlantic Richfield Co. Arco M.P.
* Approved for vendor prepack, other greases listed are for service only.