Hino 600, Workshop Manual, Page: 417 / 451

ABS (ABS : FULL AIR) BR03–14
5. MOUNTING THE WHEEL HUB AND BRAKE DRUM
(1) Refer to CHAPTER, FRONT AXLE.
NOTICE
If the wheel sensors are mounted, hammering on the wheel hubs and
the like on that axle could cause internal damage to the wheel sen-
sors. Either mount the tire and then tap on the tire or tap on the wheel
hub after removing the right and left wheel sensors.
6. MOUNTING THE WHEEL SENSOR
(1) Push in the clamping bushing until the stopper makes contact with the
knuckle's wheel sensor holder.
(2) Apply a light coating of chassis grease to the hub of the wheel sensor.
Then push it forcefully into the clamping bushing until you feel that the
wheel sensor has made contact with the sensor ring.
NOTICE
When inserting the wheel sensor, do not tap on it with a hammer or
attempt to pry it into place with a screwdriver, or the like. Doing so
could damage the wheel sensor.
(3) Slowly turn the wheel hub and brake drum and confirm that they move
smoothly.
(4) Mount the drum dust cover.
7. INSPECT THE WHEEL SENSOR
(1) Arrange the wire harness.
(2) With a circuit tester, confirm the output voltage of the wheel sensor
(By rotating the tire by one time for 2 seconds)
SHTS068020300025
SHTS068020300026
Standard: more than 200 mV
(Range of Alternating Current Voltage)