Hino 600, Workshop Manual, Page: 193 / 451

DIFFERENTIAL CARRIER (MERITOR RS17.19.21&23) DF02–33
c. Press the seal into the bearing cage. The seal flange must be flat
against the top of the bearing cage. Use a sleeve or seal driver of
the correct size that fits against the metal seal flange. The diame-
ter of the sleeve or driver must be larger than the flange diameter.
•
If a press is not available: Use a mallet and the sleeve or driver to
install the seal.
d. After the triple-lip seal is installed, a gap of approximately 0.015-
0.030-inch (0.38-0.76 mm) between the flange and bearing cage
is normal.
e. Check the gap with a feeler gauge at several points around the
seal. The gap must be within 0.015-0.030-inch (0.38-0.76 mm).
The difference between the largest and smallest gap measure-
ment must not exceed 0.010-inch (0.0254 mm).
1 PRESS
2 SLEEVE
3 SUPPORTS
4 SLEEVE
5 SEAL
6 BEARING CAGE
7 DRIVE PINION
7
4
5
1
2
3
6
SHTS05Z050200065
1 SEAL DRIVER
1
SHTS05Z050200066
1 0.015-0.030" (0.38-0.76 MM)
SHOWN WITHOUT BEARINGS AND PINION
1
SHTS05Z050200067