Hino 600, Workshop Manual, Page: 124 / 451

AUTOMATIC TRANSMISSION (ALLISON 2200RDS, 2500RDS, 2200HS) TR04–9
15. INSTALL THE SUPPORT OF THE OIL LEVEL GAUGE TO THE
ENGINE CYLINDER BLOCK.
16. INSTALL THE PROPELLER SHAFT YOKE TO THE TRANSMIS-
SION YOKE.
Tightening Torque:
61-81 N

m {622-826 kgf

cm, 45-60 lbf

ft}
17. INSTALL THE CENTER BEARING HOLDER TO THE FRAME.
18. CONNECT THE OIL COOLER LINE.
(1) For connecting the transmission case and joints, insert O-rings in the
grooves of the joints before tightening.
NOTICE
Apply automatic transmission fluid to the O-rings when inserting
them. If the fluid is not applied, the O-rings will not be inserted
smoothly and will thus be damaged, causing oil to leak.
19. REMOVE THE CAP OF THE OIL FILLER TUBE AND POUR AUTO-
MATIC TRANSMISSION FLUID INTO THE TUBE.
Automatic transmission fluid:
Refer to RECOMMENDED LUBRICANTS LIST in the chapter
“GENERAL INTRODUCTION (CHASSIS).”
NOTICE
For further details, consult your nearest ALLISON representative or
ALLISON service station.
Side view Rear view
SHTS03Z030400008
Cover
Plate
SHTS03Z030400022
SHTS03Z030400023
SHTS03Z030400024