Hino 600, Workshop Manual, Page: 131 / 451

AUTOMATIC TRANSMISSION (ALLISON 3000RDS, 3500RDS) TR04–7
12. LIGHTLY TIGHTEN THE BOLTS JOINING THE FLYWHEEL AND
THE SPACER COUPLING THROUGH THE INSPECTION HOLE. IN
ORDER TO TIGHTEN THE BOLTS, TURN THE RING GEAR WITH
A SCREW DRIVER THROUGH THE TIMING ADJUSTMENT HOLE
ON THE UPPER PART OF THE FLYWHEEL HOUSING.
NOTICE
If the ring gear does not turn smoothly with a screw driver, remove the
transmission and repeat the procedure again from 6 above, because
the hub ends of the flywheel and the spacer coupling do not fit well.
Tightening bolts in such a condition will cause damage to the bolts
and jamming of the engine.
13. TIGHTEN THE BOLTS PRETIGHTENED IN STEP 12.
Tightening Torque:
64-85 N

m {653-867 kgf

cm, 48-62 lbf

ft}
14. INSTALL THE SPEED SENSOR HARNESS TO THE REAR PART
OF THE TRANSMISSION.
15. CONNECT THE CONNECTORS OF WIRING.
16. INSTALL THE PROPELLER SHAFT YOKE TO THE TRANSMIS-
SION YOKE.
17. INSTALL THE CENTER BEARING HOLDER TO THE FRAME.
18. CONNECT THE OIL COOLER LINE.
(1) For connecting the transmission case and joints, insert O-rings in the
grooves of the joints before tightening.
NOTICE
Apply automatic transmission fluid to the O-rings when inserting
them. If the fluid is not applied, the O-rings will not be inserted
smoothly and will thus be damaged, causing oil to leak.
SHTS03Z030400019
Converter turbine sensor
Main
connector
Speed
sensor
SHTS03Z030400020
SHTS03Z030400022