ENGINE MECHANICAL (J08E)
EN02–47
2.
INSTALL THE CYLINDER LINER.
NOTICE
•
When assembling the cylinder liner with the cylinder block,
clearance can be set to three levels.
•
The upper surface and side surface of the cylinder block are
stamped A, B or C depending on the inside diameter. Insert a
matching cylinder liner having the same symbol.
(1)
Apply engine oil to the inner surface of the block bore and insert the
cylinder liner using the special tool.
SST: Guide (S0947-11490)
NOTICE
Handle the cylinder liner carefully because it is thin.
(If it falls on the floor, it cannot be used.)
3.
MEASURE THE PROTRUSION AT THE CYLINDER LINER
FLANGE.
SST: Puller (S0942-02100)
Tightening Torque:
9.8 N
m {100 kgf
cm, 7 lbf
ft}
SHTS011060200139
SHTS011060200140
SHTS011060200141
SHTS011060200142
Standard
0.01-0.08 mm {0.0004-0.0031 in.}