HighLine Bale Pro CFR651, Operator'S Manual

Page: 19 / 77

Section 2 - Transporting the CFR 651
1. Tractor Requirements
- Roll Over Protection System (ROPS)
- Working seatbelts
- 1 3/8" 21 spline PTO
- PTO requirement
-
refer to the "Specifications"
Section for the PTO requirements.
- 3 Selective Control Valves (SCV)
-
An optional solenoid valve is
available for tractors with 2 SCV.
2. Ensure the correct PTO speed.
- Ensure that the tractor PTO speed
matches the CFR 651’s gearbox
speed of 1000 rpm.
- Do not attempt to operate the CFR
651 at a different PTO speed.
Note: Do not use PTO adapters.
PTO adapters will cause a
driveline failure and possible
tractor damage. Your CFR 651
warranty will also be invalid.
3. Adjust the tractor drawbar length.
- Set the drawbar length to 16" (406
mm) for a 1 3/8" 21 spline PTO.
- This length is measured from the tip of
the PTO shaft end to the center of the
drawbar hole. (Refer to your tractor’s
operator manual for drawbar
adjustment procedures.)
Note: To prevent damage to the tractor
drawbar, avoid traveling at high
speeds and over rough terrain.
Tractor Drawbar Adjustment
PTO Dimensions
Page 2-2