b) In the Identify Actions section, select UID LED ON and set the Server Identify Timeout.
Figure 105: Server Identify
c) Click Perform Action.
The Server Identification LED will illuminate to indicate that it is the enclosure being accessed.
3.
From the rear of the enclosure, disconnect the all of the cables attached to the enclosure.
a) Remove the 10G SFP+ cable from the NIC port (1).
b) Remove the Ethernet cable from the enclosure (2).
c) Remove the power cord by pulling firmly, but do not jerk it out of the unit (3).
Figure 106: Rear IO Ports
85
3
Part Replacement
User Guide
3.7
CPU and Heat Sink Module Replacement
