Heliocentris Energy Manager 1.3, Instruction Manual

Page: 35 / 78

Operating
Energy Manager 1.3 - Instruction Manual 35
5.1.2 System Submenu (Sys)
Submenu Menu item Display Description I/C
Info OpMode 1 of the modes: Operation mode of the EM. The mode is also
displayed in the main menu if no error
occurred.
Init Software module initializes I
Active System is running I
Error Error detected I
Epoch_start Up to 8 digits Time stamp of initial start time in seconds since
Jan 1, 1970 I
Reset
epoch_start* Up to 8 digits Reset of initial start time stamp by service staff C*
Error list Number in
hexadecimal format
All active events are displayed one after
another with their number and a short text, and
can be confirmed.
I+C
Alarm Unit IOM3 Unit 1 to 8 1 of the states:
Ignore Relay is switched by control SW. I+C
Off Relay always off I+C
On Relay always on I+C
Default Reset to default values I+C
IOB4 Unit 1 to
16
1 of the states:
Ignore Relay is switched by control software. I+C
Off Relay always off I+C
On Relay always on I+C
Default Reset to default values I+C
Network IP IP address in format:
aaa.bbb.ccc.ddd
IP address of the controller I
NM Netmask in format:
aaa.bbb.ccc.ddd Netmask I
GW GW address, format:
aaa.bbb.ccc.ddd Gateway address (no gateway: 0.0.0.0) I
Mode 1 of the states: Integration of EM into the network
dhcp Dynamic host configuration protocol I+C
static Manual network configuration I+C
Static Setup IP address Set IP manually C
Network mask Set network mask manually C
Gateway address Set gateway manually (no gateway: 0.0.0.0) C
Save Net Cfg* Save network configuration S*
Modem Usage
-
Usage of the modem:
-
Not used
-
SMS: send outgoing / receive incoming
-
Updating status: change between two
states
I
Error I