Hawk HA-FM10, Manual

Page: 11 / 36

14. Channel 2 output choosing
Channel 2 output can program to 0.8 sec pulse for opening trunk, 25 sec pulse for
closing window, or 30 sec potential pulse. Factory default setting is 0.8 sec.
1. Remote open boot
Press and hold button III 2 sec, the main unit channel 2 output
-250mA pulse 0.8 sec to open the boot. Remote sound “Bi-”
and screen shows “ ”.
Note:
1. Lever boot can not be opened.
2. In arm status, open the boot, system will be disarmed and door will be unlocked.
3. In arm status, if boot is opened illegally, siren will sound 25 sec, and lights will
flash at the same time, car can not be started. Remote will show “ ” and will
sound “Bi-Bi-Bi-”.
2. Close window(comfort output)
Simply press button I shortly to arm your system, the main unit channel 2 output
-250mA pulse 25 sec to close window. Simply press button II will stop close win-
dow, the same time system will be disarmed.
3. Potential pulse
Press and hold button III 2 sec, the main unit channel 2 output -250mA potential
pulse 30 sec, you can press and hold button III 2 sec to stop it.
15. Clock setting
Press and hold button IV ( F )2 sec, remote controller sound “Bi-”
, clock hour figure will flash and system enter into clock hour set-
ting status. At this time, press button I shortly, figure will add 1,
press and hold button I , figure will add 1 continuously. Press but-
ton II shortly, figure will reduce 1, press and hold button II , figure
will reduce 1 continuously. Press button III shortly to confirm.
Press button IV ( F ) shortly, remote controller sounds “Bi-”, clock
minute figure will flash, system will enter into clock minute setting
status. At this time, press button I shortly, figure will add 1, press
and hold button I , figure will add 1 continuously. Press button II
shortly, figure will reduce 1, press and hold button II , figure will reduce 1 continu-
ously. Press button III shortly
Press and hold button IV ( F ) 2 sec, remote controller sounds “Bi-Bi-”, clock setting
exit. If user do not press and hold button IV ( F ) 2 sec to exit after setting, time
figure will flash 10 sec to exit automatically.
16. Temporary Isolation of Shock / Ultrasonic Sensors
Press and hold button IV ( F ) 2 sec, then press button IV ( F )
shortly many times, till remote controller LCD screen icon
“ ” flashes.
At this time, press button I shortly, remote controller sound
“Bi-”, LCD screen shows “ ON ”, shock sensor alarm func-
tion is ON, system can receive shock sensor alarm signal.
8