SONNET AUTO SET ALARM CLOCK RADIO
WITH BLUETOOTH AND USB CHARGING
MODEL NO. R-1428
Power Source
DC Power – To power the unit, plug the DC power adaptor into a standard wall outlet.
Battery Back Up – Requires 1 x CR2032 Button Cell Battery (included). The battery backup is intended for short power outages only. The unit’s
primary functions cannot run on the battery backup alone. This unit uses a button cell battery that will last up to 1 year and maintains the time.
Replace the battery if the low battery indicator lights up.
Clock and Sleep
Setting the Clock
Auto Set – When the clock radio is connected to an AC power outlet for the first time, the correct time for Eastern Standard Time zone will be
shown. You can change to the other time zones by following the instructions in Time Zone selection below.
Manual Time Set Up
1. With the power off, press and hold the MEMORY / CLOCK BUTTON to set up the clock.
2. Press the SKIP / TUNE BUTTON to adjust the hour.
3. Press the MEMORY / CLOCK BUTTON again to confirm the hour and minutes on the display will begin flashing.
4. Press the SKIP / TUNE BUTTON to adjust the minutes.
5. Press the MEMORY / CLOCK BUTTON to finish setting the minutes and day of the week (d1 to d7) on the display will begin flashing.
NOTE: “d1” is Monday; “d2” is Tuesday and so on to “d7” which is Sunday.
6. Press the SKIP / TUNE BUTTON to adjust the day of the week.
7. Press the MEMORY / CLOCK BUTTON to finish all settings.
FUNCTION KEYS
1. Power / Source Button
2. Skip / Tune Backward / DST (Daylight Saving) Button
3. Play / Pause / Bluetooth Pair / Scan Radio Button
4. Volume Down / Alarm One Button
5. Dimmer / Snooze / Sleep Button
6. Memory / Clock Button
7. Skip / Tune Forward / Time Zone Button
8. Volume Up / Alarm Two Button
9. PM Indicator
10. Alarm One Indicator (Buzzer / Radio)
11. DST (Daylight Saving Time) Indicator
12. Bluetooth Mode Indicator
13. Alarm Two Indicator (Buzzer / Radio)
14. Low Back Up Battery Indicator
15. FM Antenna
16. Aux In Jack
17. Back Up Battery Compartment
18. USB Charging Port
19. DC Jack
