Hawk HA-FM10, Manual

Page: 18 / 36

When the engine temperature below –10°c, 10 sec later engine will auto start. At
this time, engine will work 10 min continuously (user can set it to 20 min or 30
min). At this time, if temperature below –10°c, engine will auto start again.
If the temperature below 20°c after engine start twice continuously, system will can-
cel low temperature auto start function in this anti-theft cycle. Disarmed and armed
again, this function will be available.
If low temperature start is not successful, system will auto start 2 min later. If the
second start is still not successful, system will cancel low temperature auto start
function in this anti-theft cycle. Disarmed and armed again, this function will be
available.
Default setting low temperature auto start function is OFF, but always valid after
setting ON. If you don’t need this function, please set OFF.
34. Low car storage battery level auto start function
Press and hold button IV ( F ) 2 sec, then press button
IV ( F ) shortly many times, till the remote screen icon
“ ” flashes.
At this time, press button I shortly, remote sounds “Bi-”, screen
shows “ ON ”, low car storage battery level auto start
function is ON. When car battery voltage is lower than the
initialization (11.5V), engine will auto start 10 sec later.
At this time, press button II shortly, remote controller will
sound “Bi-”, screen will show “ OFF ”, low car storage
battery level auto start function is OFF.
35. Call from the car function
Press button on antenna, LED will blinks and turning light flash 3 times. At this
time, remote controller will receive CALL signal from car, buzzer will sound 25 sec
and LCD screen will show “ ” icon.
36. Revise PIN code
In disarm status,
1. Switch ON ignition,
2. Press button I + III, siren sound once, LED will be glowing continuously.
3. Enter into the first old PIN code (press “Emergency switch” M times, M is the
first PIN code number).
4. Switch OFF ignition, 0.5 sec later and within 2 sec, switch ON ignition.
5. Enter into the second old PIN code (press “Emergency switch” N times, N is the
second PIN code number).
6. Switch OFF ignition, 0.5 sec later and within 2 sec, switch ON ignition, if siren
sounds 3 times, PIN code will be wrong, please repeat above procedure; if siren
sounds once, PIN code will be right, please follow below procedure:
7. Enter into the first new PIN code (press “Emergency switch” X times, X is the
first new PIN code number).
8. Switch OFF ignition, 0.5 sec later and within 2 sec, switch ON ignition.
9. Enter into the second new PIN code (press “Emergency switch” Y times, Y is
the second new PIN code number).
10. Switch OFF ignition, 0.5 sec later and within 2 sec, switch ON ignition.
15