Hawk HA-FM10, Manual

Page: 19 / 36

11. Please repeat 7. ~ 10. procedure, enter into new PIN code again, if siren sounds
twice, new PIN code will be correct and saved; if siren sounds 3 times, system will
exit revising PIN code status, new PIN code is invalid.
Note:
1. During entering into PIN code, if user do not press “Emergency switch” within
10 sec, system will exit entering into PIN code.
2. Effective number is 1 to 9, if Pin code is wrong when entering into PIN code,
siren will sound 3 times.
3. Default setting Pin code is 11, user can revise it anytime.
4. In revising PIN code status, press I + II + III shortly, PIN code will recover to
default setting.
37. Remote controller learning
In disarm status, close the door, following below steps:
1. Switch ON ignition, if you hold the “Emergency switch”, the siren will sound
twice, turning light will flash twice.
2. Press any button of the remote controller, the turning light will flash once, the
remote controller learn successful. Learning another remote controller with same
method.
3. After leaning code, release the “Emergency switch”, then the new remote con-
troller is already available but the old ones is cancelled accordingly.
Note:
Each main box can match at most 2 remote controllers. When learning the new
remote controller, the old remote controller can not be used.
38. Emergency disarm
When remote controllers lost or damaged, and you can not use remote to release
arm, Please use PIN code to release arm (enter into effective PIN code, default set-
ting is “11”) as following:
1. Open the door.
2. Switch ON ignition.
3. Enter into the first PIN code (press “Emergency switch” M times, M is the first
PIN code number).
4. Switch OFF ignition and then switch ON.
5. Enter into the second PIN code(press “Emergency switch” switch N times, N is
the second PIN code number).
6. Switch OFF ignition and then switch ON.
39. Emergency set arm function
If remote is damaged, user can set arm by hand. In disarm status:
1. Turn the ignition switch from OFF to ON position, repeat 3 times and stop ON
position, siren will sound once, LED will be glowing continuously.
1. Press “Emergency switch” 8 times within 10 sec.
2. Switch OFF ignition. If setting is right, siren will sound once, and turning light
will flash once; otherwise LED will stop flash.
3. Get off the car and close the door, system enters into arm status but door will not
be locked; if do not close the door, system will arm automatically after 30 sec later.
16