HappyJapan HCH-701-30, Maintenance Manual

Page: 168 / 171

1 54
Error and measure
7-3-1
No. message Error measure page
111 Change over While reading pattern data, the (1)
Modify pattern data and reduce frequency of color
frequency of color change (color No.)
change of one pattern to less than 250 times.
exceeded 250 times. (2)
Divide pattern data and reduce frequency of color
change of one pattern to less than 250 times.
112 Data error Pattern data of pattern to be (1)Read pattern data again from the first. (5-4)(5-6)
embroidered is damaged. (2)Read pattern data again if you have
a backup data.
114 Id over
The number of pattern in memory has Delete unnecessary patterns and read. (5-5)
reached maximum of 250. (5-B)
118 Trace data over
The stitch number counts over 1024 Set Embroidery area of pattern data within
stitches during preparing Trace data. 2m(X) x 2m(Y).
120 Memory error It became impossible to retain contents (1)Replace the battery for memory backup. 4-1-2
of memory. (2)Replace the LCD-CE-U board ass'y if recurs
even change the battery.
130 Card error Incapable of disposing of USB memory
(1)
Turn off power source once and turn it on again.
continuously. (2)
USB Memory reading processor may defective.
Replace the circuit board.
131 Card no ready USB Memory is not set. Check if USB memory is properly set. (5-5)
133 Bad card
USB Memory is not proper or broken. (1)
USB Memory might be not readable with the machine.
(5-5)
Prepare readable USB memory for the machine.
(2)
USB Memory card might be defective.
Prepare another memory card which is not defective.
(3)
Initialize the USB memory if it is not initialized.
141 Not found name Designated pattern is not found.
USB Memory might be not readable with the machine.
(5-5)
Prepare readable USB memory for the machine.
190 Cut blade Thread cut knife is not at stop position. (1)Restore the moving knife to stop position. (24-5)
(2)Modify the adjustment if the problem repeats.
193 Catcher Thread catch hook is not in its (1)Check if mistake is found in thread cut. (24-6)
stop position. If found, cut thread and move thread catch
hook to proper position
.
(2)Adjust and correct trouble that hinders motion
of thread catch hook.
( ) ---Reference instruction book