Hamilton Jet HJ241, Manual

Page: 152 / 202

A.12
Appendix
HJ-241 / HSRX
A-4 Commissioning Checks
Refer to relevant Controls Product Manual for commissioning of the Controls System.
1 Pre Launch Checks
Item
No.
Checks to be Carried Out Completed
1.1 Check that the plastic spiral wrap protective cover (where fitted) has been
removed from hydraulic shafts (HM-Models only). Check all hydraulic
shafts for damage and check that they are free from contamination (weld
splatter, grinding dust, fibreglass resin, etc).
1.2 Check that all the Jet Unit inspection covers are correctly fitted and secured.
1.3 Check that all the Anodes have been fitted and that they have not been
painted over. Refer to Anode Location Drawing.
1.4 If the Steering Assembly, Tailpipe or Reverse Duct have been removed during
jet installation, check that all fasteners securing these items have been
torqued correctly.
Remarks:
2. Post Launch Checks:
Item
No.
Checks to be Carried Out Completed
2.1 Check for water leaks at the Transom Seal, Intake base, and from under the
Bearing Housing (Water Seal leaking).
2.2 For oil lubricated Main Bearings (HJ-362 and above), check that the correct
Dipstick is fitted and that oil level is correct (Dipstick length is dependent on
the deadrise angle of the Jet Unit). For HM-651 to HM-811, check that the
Dipsticks are on the correct side (Refer to the Dipstick drawings in the Prod-
uct Manual).