SPANNTOP [nova] – Assembly
WARNING!
Danger of violent pressure to hands and
fingers!
Before working at the installed clamping devi-
ce make sure that starting of the machine is
impossible.
Only run the machine in set-up mode or jog
mode.
During operation never reach into the coup-
ling or slot area of the clamping head nor in
the changing fixture.
6.3.12 Assembly of the workpiece end-stop
7. x
Special tools required:
Allen wrench
Fig. 68
1. Put the workpiece end-stop through the assemb-
led clamping head into the clamping device.
NOTE!
Material damage is possible if the moun-
ting screws are tightened too forcefully!
Tightening the mounting screws too forceful-
ly can damage or destroy them.
Tighten the mounting screws by hand.
Do not screw in beyond the resistance.
2. Screw in and firmly tighten mounting screws.
WARNING!
Risk of injury!
Tools and gages that are thrown out of the ma-
chine can cause injury.
Remove all tools and gages from the working
area of the machine before the machine is
started up.
83
