SPANNTOP [nova] – Assembly
NOTE!
Material damage is possible if the eye bolts
are left in the spindle flange!
Eye bolts that are left in the clamping device
can significantly damage or even destroy lathe,
clamping device and workpiece.
Always remove eye bolts immediately after
mounting the clamping device in the lathe.
6.3.2 Adjusting the concentricity of the spindle flange
6. x
NOTE!
Material damage due to insufficient face run
and concentricity!
Due to insufficient face run and concentricity
workpieces can be damaged during proces-
sing.
After each mounting check, and if necessary
readjust, the face run and concentricity of the
clamping device.
Auxiliary material required:
Dial indicator
Rubber mallet
Torque wrench
Fig. 35
1. Wipe off the mating surfaces of the spindle flange
with a soft, lint-free cloth and remove all oil and
grease residues.
2. Place the magnetic base of the dial indicator on
the inside of the machine.
3. Place the dial indicator for concentricity on the fit
of the spindle flange.
Fig. 36
4. Adjust the spindle flange in such a manner that the
dial indicator shows the value »0« [≤ 0,005 mm].
70
