H2fl ow Controls
ProcessDefender™
43
Programming
H2fl ow Controls
ProcessDefender™
42
Programming
⊲
Menus 4.1.2 and 4.1.3 - Pre-Alarm Relay (R2) Overload and Underload
Trip points
Important Notes:
1.
Depending on what was set in 2.7.1, one of the screens below (Figs.5.8; 5.9; 6.0) will
be seen:
2.
Each of the screens assumes that you have set 4.1.1 to Pre-Alarm for Overload. If
Pre-Alarm for Underload has been selected in 4.1.1 then the menu screen will be
4.1.3. If Pre-Alarm for both Overload and Underload has been selected, 4.1.2 will
appear and aft er programming that screen, 4.1.3 will appear.
Fig.5.8
Fig.5.9
Fig.6.0
To make changes to 4.1.2, press the
or
button. The display will now appear as
shown in Fig.6.1 (below):
Fig.6.1
Press the
or
buttons to adjust the underlined number and then press the
button to move to the next digit. Next, press the
button to accept the
complete entry.
Repeat this procedure for 4.1.3 if Underload protection or both Overload and
Underload protection was set in 4.1.1.
The screen will now show either 4.2.1 or 4.2.2 (depending on what was set in 4.1.1).
