H2fl ow Controls
ProcessDefender™
29
Programming
H2fl ow Controls
ProcessDefender™
28
Programming
⊲
Menus 2.9.1 and 2.9.2 - Time and Date
Section 4.3 of this manual describes how you will check for - and install - any
Firmware updates that may have occurred since your unit was manufactured. When
undertaking this procedure, the ProcessDefender will automatically update the units
current time and date from the PC being used.
Menu 2.9.1 will show the current time and Menu 2.9.2 will show the current date as
shown in the following examples:
Format:
Hour.Min.Sec. (24-hour
format, i.e., 10:30PM = 22.30.00)
Format:
Year.Month.Day
The Time and Date will be used for the ProcessDefender’s Event Log feature as
discussed in Section 6 of this manual.
⊲
Menu 2.8.1 - Motor Supply Voltage
To enable the PD100 to provide a warning of an abnormal voltage condition, it is
necessary for you to program menu 2.8.1 to refl ect the motor supply voltage.
If you arrived at Menu 2.8.0, press the
button to display 2.8.1.
In the top-left -side of the display, you will now see three digits which will allow you
to enter a motor supply voltage up to 999 Volts. Lets us assume that your motor supply
voltage is 480V. To enter a value, you will automatically start with the left -hand digit.
For this example, we want to:
1.
Leave the fi rst digit as ‘0’, so press the
button.
2.
Program the fi rst digit to ‘4’ by pressing the
button four times followed by
the
button.
3.
Program the second digit to ‘8’ by pressing the
button eight times to display
the number ‘8’ followed by the
button to accept.
4.
For the third digit, you will press the
button to accept the ‘0’.
The display will show ‘SAVED’ for two-seconds and automatically move to the main
menu 2.0.0.
Fig.3.7
Fig.3.8
