K-BUS
®
KNX/EIB
Dimming Actuators
8
1.3. Dimming Controller, 4fold, 0/1~10V
0/1~10V DC control device with standard DC 0/1-10V control interface, can be connected with electronic
dimming ballast/EVG or other devices with 0/1-10V interface to control the lights, such as dimming, scenes,
switching and so on.
The 0/1-10V DC control device has embedded switching relays for 23 ECG/18W, 14 ECG/36W, 11
ECG/58W or23 ECG-T5/24W. Each channel offers control voltage up to 23 electronic control gears (ECG).
The devices adopt screw terminals to achieve electrical connection; the connection to the KNX bus is
established via a bus connecting terminal. There is no additional voltage input. The following list provides a
functional overview:
◆
Switching the light
◆
Relative dimming
◆
Absolute dimming
◆
Status report
◆
Setting 15 scenes
◆
Staircase lighting function
◆
Preset value and modify preset value functions
◆
Bus recovery (or reset) function
◆
Switch/relative dimming via manual buttons
The above function of parameters to configure and use are described in the chapter 5, the device has own
database file (.vd4) (ADTV-04/16.1). And to set the output voltage type in the parameter according to the interface
type of load, as 0-10V or 1-10V.
There is an electronic manual operation function in the normal dimming mode, but it is invalid in the
staircase lighting mode. Switch via a short operation of the electronic manual buttons, relative dimming via a long
operation, and in the case of the bus voltage fail the manual operation is invalid. There is also mechanical manual
operation function, and it can switch on or off the output at any time.
Note: Some lights cannot be turned off completely by dimming. In this case, you can turn off the lights
via switching.
