Guldmann GH2, Installation Manual

Page: 67 / 109

A
F
G
E
C
E
B
H
H
D
C
F
G
E
©
Guldmann
GB
-1394/11/08
6
4.
e
le
ct
rI
ca
l
co
n
n
ec
tI
o
n
Combi-lock
CL, double electrical
Comprises:
• two safety locks for fixed rail
• two safety locks for traverse rail
• one motor unit
The Double Combi-lock is used at the transition between
two room-covering rail systems to provide optimum safety
when the two rail systems are used together .
The function of the Double Combi-lock:
Engagement: Two tongues are inserted to link the traverse
rails with the fixed rail, and the safety locks open .
It is now possible to run the hoist between the room-cove-
ring systems .
Disengagement: The tongues that link the systems are
drawn back and the safety locks close .
The traverse rails are released and the safety locks prevent
the hoist from running out of the rail systems .
Safety locks must always be installed on fixed rail and on
traverse rails . The combination of these and the travelling
mechanism (electrical or manual) is collectively designated
the Double Combi-lock .
A . The transformer wires, 24V AC, are connected to the
PCB . Transformer: 110/240V AC - 24V AC .
B . Flexible installation of the Double Combi-lock is pos-
sible . The safety locks for fixed rail are supplied with
tongues and standard threaded spindles of 600 mm
(24") in length . The length of the threaded spindle must
be adapted to the specific installation . Longer threaded
spindles, up to 1000 mm (40") in length, can be sup-
plied . This makes it possible to install the safety locks
for fixed rail and the motor unit at a considerable
distance from each other if this is appropriate
for the installation in question .
C . The Combi-lock brackets are always supplied with the
safety locks for fixed rail and must always be used
together with standard ceiling brackets or any extended
ceiling brackets .
D . Hand control .
E . Ceiling bracket, use the bracket as a drill gauge . For
service and maintenance considerations it is best to use
at least 5 mm (
1
/
4
") spacers beneath both fittings for
permanent and parallel tracks above the Combi-Lock .
F . Mini rail .
G . The electrically activated Double Combi-lock is equip-
ped with electric sensors . The sensors are connected
in
parallel to the PCB with connectors (brown/brown
and blue/blue) . The distance between the sensor and
the switch must be equal to the distance between the
two rails, max 1-1 .5 mm (
1
/
16
" -
3
/
32
”) . Note: The sensor
must never be adjusted so that it can collide with the
switch .
H . The traverse rails are Maxi or jumbo rails which have
been reduced to the height of a Mini rail in the place
where the safety locks for the traverse rails are installed .