Guldmann GH2, Installation Manual

Page: 57 / 109

A
B
C D E
F
Blue
Red
White
Green
Charge
.2
Motor
2
Brown
Blue
1
2
3
4
5
.
L
Blue
Brown
Battery plug
Blue
Brown
Motor
1
©
Guldmann
GB
-1394/11/08
4.
e
le
ct
rI
ca
l
co
n
n
ec
tI
o
n
The room-covering drive motor
is installed as described:
• Travelling trolleys are placed in the two parallel rails
so that the motors/covers face inwards towards the
traverse rail .
• The battery box is fitted/hooked on at the top of the
traverse rail .
• Position two charging stations, one in each parallel rail .
One for charging the hoist and one for charging the
room-covering drive motor (the battery pack) .
• The two drive motors/traverse travelling trolleys must
be connected with each other in parallel . The wire (not
included) should be drawn through the traverse rail from
position 1 (blue) and position 2 (red) across to the other
drive motor and connected to the motor . It is necessary
to remove the plastic covers .
• The battery pack must be connected to the terminal
board in the drive motor, + in position 4 (green) and
– in position 3 (white) .
• The three-pin plug to the battery pack must be
connected with + on N and – on L .
• The wire on the infra-red receiver should be plugged
directly into the plug on the traverse travelling trolley and
the infra-red receiver placed on the plastic cover on the
traverse travelling trolley .
• If the motors run in different directions, the wires
connected to the terminal board for motor 2, positions 1
and 2, should be reversed .
Traverse drive motor