Guldmann GH2, Installation Manual

Page: 66 / 109

©
Guldmann
GB
-1394/11/08
6
4.
e
le
ct
rI
ca
l
co
n
n
ec
tI
o
n
Combi-lock
CL manual
Installation of the Manual Combi-lock
Mount changeover mechanism on safety lock for fixed rail
with the accompanying screws .
Installing the safety lock on fixed rail
• The safety lock for the fixed rail and tongue are pushed
together into the T track in the Mini rail .
• The safety lock should be installed so that its edge is
flush with the front edge of the rail .
• Fasten the safety lock with two M4 x 10 mm locking
screws .
• Use the safety lock as a drill gauge and hold it precisely
in position while drilling . A screw clamp can also be
used to keep the safety lock in position while drilling .
Bottom of safety lock must fit tightly against bottom of
rails .
• Drill the holes and make the M4 threads . Clean up com-
ponents and mount the screws .
• Install bracket for Combi-lock . Before finally fastening
the bracket, check that the rail is level, both horizontally
and vertically . If necessary, adjust the bracket .
Installing the safety lock on traverse rail
• Loosen the M8 nuts in the T track plate so that the
safety lock can be pushed into the T track of the rail .
• The safety lock should be installed so that its edge is
flush with the front edge of the rail .
• When the safety lock has been correctly installed,
the two M8 nuts can be tightened .
• Check that the there is a space of minimum 1 mm (
1
/
16
")
from the activation pin in the T track to the bottom of the
T track .
• Fasten the safety lock with one M4 x 10 mm locking
screw .
• Use the safety lock as a drill gauge .
• Drill the holes and make the M4 threads . Clean up
components and mount the screws .
Important
After installation has been completed, check that the locks
work in combination and that they open and close correctly
individually .
All parts have been lubricated from the factory .
Do not lubricate or grease any components or rails .