GTS BG 132, Installation And Operating Manual

Page: 63 / 128

Page 63 Issue 05/2013
Installation of generator
Installation of dual-bearing generators (BG 132)
6.7.5.2 BG 132 hydraulic drive with reinforced bearing plate
Preparatory disassembly
>
Carry out the preparatory disassembly on the generator.
Ö
Preparatory disassembly, page 59
Ö
Fig. 18, Preparatory disassembly of flange mount
(dual-bearing, BG 132 model with reinforced bearing plate), page 59
Assembly
Ö
Fig. 21, Assembly of flange mount hydraulic drive
(dual-bearing, BG 132 model with reinforced bearing plate), page 64
>
Place the flange [1] onto the generator and secure with four screws [2a] to
a tightening torque of 75 Nm. Place a toothed washer [2b] underneath the
screws and secure with Loctite. Tightening torque 75 Nm.
>
Mount the first half of the coupling [3] on the shaft at the generator and
prevent it from twisting on the shaft using with a key. When carrying out
the attachment, follow the instructions of the coupling manufacturer.
>
Mount the washer [4] onto the hydraulic motor [6] . Depending on the
hydraulic motor, prepare the necessary screws and tighten them according
to the instructions of the manufacturer of the hydromotor.
>
Place the second half of the coupling [3] to the hydraulic motor. When
carrying out the attachment, follow the instructions of the coupling
manufacturer.
>
Place the hydraulic motor [6] with washer [4] and the second half of the
coupling on the generator.
>
Where necessary, turn the coupling slightly to ensure the gearing locks.
>
Place toothed washers [5b] to eight screws [5a] and secure disk [4] to the
flange [1] . Tightening torque 24 Nm.
>
Place the collar [7] onto the coupling unit and tighten firmly with two
screws.