GTS BG 132, Installation And Operating Manual

Page: 61 / 128

Page 61 Issue 05/2013
Installation of generator
Installation of dual-bearing generators (BG 132)
6.7.5 Assembly instructions for hydraulic drive
6.7.5.1 Hydraulic drive for BG 132 model with standard bearing plate
Preparatory disassembly
>
Carry out the preparatory disassembly on the generator.
Ö
Preparatory disassembly, page 57
Ö
Fig. 16, Preparatory disassembly of for flange mount
(dual-bearing, BG 132 model with standard bearing plate), page 57
Assembly
Ö
Fig. 20, Assembly of flange mount for hydraulic drive
(dual-bearing, BG 132 model with standard bearing plate), page 62
>
Place the flange [2] onto the generator and secure with four screws [4a]
and nuts [3a] to a tightening torque of 47 Nm.
>
Place a toothed washer [4b] underneath the screws and secure with
Loctite.
>
Place toothed washers [2b] underneath the nuts.
>
Place the collar [1] and clamp securely with two screws.
>
Mount the first half of the coupling [5] on the shaft at the generator and
prevent it from twisting on the shaft using with a key. When carrying out
the attachment, follow the instructions of the coupling manufacturer.
>
Mount the washer [6] onto the hydraulic motor [8] . Depending on the
hydraulic motor, prepare the necessary screws and tighten them according
to the instructions of the manufacturer of the hydromotor.
>
Place the second half of the coupling [5] to the hydraulic motor. When
carrying out the attachment, follow the instructions of the coupling
manufacturer.
>
Place the hydraulic motor [8] with washer [6] and the second half of the
coupling on the generator.
>
Where necessary, turn the coupling slightly to ensure the gearing locks.
>
Place toothed washers [7b] to eight screws [7a] and secure disk [6] to the
flange [2] . Tightening torque 24 Nm.
>
Place the collar [9] onto the coupling unit and tighten firmly with two
screws.