GTS BG 132, Installation And Operating Manual

Page: 71 / 128

Page 71 Issue 05/2013
Installation of generator
Installation of dual-bearing generators (BG 160)
6.8.5 Assembly instructions hydraulic drive
Preparatory disassembly
>
Carry out the preparatory disassembly on the generator.
Ö
Preparatory disassembly, page 69
Ö
Fig. 22, Preparatory disassembly of flange mount (BG 160 model),
page 69
Assembly
Ö
Fig. 24, Assembly of flange mount hydraulic drive (BG 160 model),
page 72
>
Place the flange [1] onto the generator and secure with four screws [2a] to
a tightening torque of 75 Nm.
>
Place a toothed washer [2b] underneath the screws and secure with
Loctite. Tightening torque 75 Nm.
>
Mount the first half of the coupling [3] on the shaft at the generator and
prevent it from twisting on the shaft using with a key. When carrying out
the attachment, follow the instructions of the coupling manufacturer.
>
Mount the washer [4] onto the hydraulic motor [6] . Depending on the
hydraulic motor, prepare the necessary screws and tighten them according
to the instructions of the manufacturer of the hydromotor.
>
Place the second half of the coupling [3] to the hydraulic motor. When
carrying out the attachment, follow the instructions of the coupling
manufacturer.
>
Place the hydraulic motor [6] with washer [4] and second half of the
coupling to the generator.
Where necessary, turn the coupling slightly to ensure the gearing locks.
>
Place toothed washers [5b] to eight screws [5a] and secure disk [4] to the
flange [1] . Tightening torque 24 Nm.
>
Place the collar [7] onto the coupling unit and tighten firmly with two
screws.