GTS BG 132, Installation And Operating Manual

Page: 43 / 128

Page 43 Issue 05/2013
Installation of generator
Installation of single-bearing generators
1
4x
2
Install a appropriate
seal for the drive motor
Fig. 8 Assembly of single-bearing brush generators on the drive motor
6.6.4.4 Installation of carbon brush holder
Ö
Fig. 9, Installation of carbon brush holder, page 44
>
Insert the carbon brush holder [4] into the generator in the correct
position.
>
Push onto the slip rings on the shaft so that the carbon brushes are
pressed into the carbon brush holder and the carbon brush holder is
resting against its mounting base.
>
Press the carbon brush holder further and thread in the mounting
screw but do not tighten fully yet. Threading in the mounting screw
automatically positions the carbon brush holder on the mounting base.
>
Check the correct position of the carbon brush holder and then tighten
the mounting screw.
>
Insert both connection lines onto the connector plugs of the carbon brush
holder according to the size of the attaching plug.