FOR yOUR SAFETy
10
CoboSafe-CBSF
325-2810-012US15
2.4
Residual Risk When Using CoboSafe-CBSF Force Gauges
Please read the chapter "Residual risks" in the corresponding document "CoboSafe – General
Safety Instructions".
Attention!
The measurement setup must meet requirements regarding stiffness and at the same
time guarantee stability. Therefore, hard and stiff components must be used, which
must be firmly connected to each other. Depending on the measurement setup,
burrs, corners and edges can cause cut and impact injuries, for example when
using aluminum profiles. Falling or tilting components of the measuring setup can
cause injuries.
GEFAHR
WARNING
Dangerous measurement setup
Risk of injury due to improperly erected measurement setup!
■
Establish measurement setup only with deburred compo-
nents.
■
Upholster corners and edges.
■
Secure measurement setup against unauthorized access.
■
Wear specified protective equipment.
■
Secure the measurement setup against tilting.
If the measurement setup is established using sharp edged com-
ponents or has sharp corners, this can result in cuts and impact
injuries. Tilting parts of the measurement setup (e.g., due to low
stability) can cause impact and crushing injuries.
GEFAHR
WARNING
Falling components
Risk of injury from dropping or dropping components!
■
Keep order in the workplace.
■
Keep work surfaces free for assembly and storage of
components.
■
After use, store unused components as described in this
manual.
■
Handle all components with care.
■
Always hold the force sensors at the side for lifting and
positioning and make sure that the display and switch are
not touched.
■
Wear specified personal protective equipment.
Some components of the measuring system are heavy and hard.
If force sensors, mounting adapters, transport cases, film rolls
or the scanner are dropped, severe injuries up to crushing and
bone fractures can result.
