GSi TopDry Autoflow, Construction Manual

Page: 78 / 142

Chapter 7: TopDry Drying Floor
Assembling the Inside Cable Pulley
Before You Begin
Make sure that the cross angle is installed in the center collar.
1. Install the inside cable pulley bracket (B) to the cross angle in the middle of the center collar
assembly using 3/8 x 1 in. HHCS bolt (C).
2. Install the pulley (A) between the inside cable pulley bracket (B) using 3/8 x 1-7/8 in. shoulder
bolt (D), 3/8 in. sealing washer (E) and 3/8 in. hex nuts (F).
Figure 7-17 Assembling the inside cable pulley
A
Pulley assembly (TD-101360)
D
3/8 x 1-7/8 in. shoulder bolt (S-4749)
B
Inside cable pulley bracket (TD-100022)
E
3/8 in. sealing washer (S-3558)
C
3/8 x 1 in. HHCS bolt (S-8671)
F
3/8 in. hex nut (S-456)
78 PNEG-4936 36 Ft. TopDry Autoflow