Two Ring Door Installation Instructions
Standard Two-ring door (WD-6242) to be used for bins with 3 to 9 ring heights.
Heavy Two-ring door (WD-6244) to be used for bins with 10 to 13 ring heights.
Before You Begin
Before starting to install, make sure the correct door has been received.
NOTE:
Refer to PNEG-301 for detailed assembly instructions.
1. Remove the inner door panels (Q, R and S) and outer door cover (A) from the door assembly.
NOTE:
Place the top of the door frame to the inside of the sidewall and the bottom of the door frame
to the outside of the sidewall. Therefore, depending upon the location and overlap, caulk will
be applied on either the inside or the outside of the door flanges.
2. Apply two rows of rope caulk around all four door flanges: On vertical flanges, one row of caulk
should be applied between the two vertical rows of bolts and the other row of caulk should be
applied between the door frame and the first row of vertical bolts. On the horizontal flanges, a row of
caulk should be applied on each side of the row of bolts.
3. Align the holes in the door frame with the holes in the sidewall opening. Insert a bolt at the four
corners of door frame and sidewall, but do not tighten until completing
.
4. Re-install the inner door panels (Q, R and S) at original locations. Close latch bars (J) to lock panels
in place. Make sure that panels are fully seated over all bearing pins (O). Install the inner panel
hinge (H, I and J) assemblies as per illustration instructions with hinges.
NOTE:
Do not distort door frame with use of alignment or drift punches - if necessary, drill or ream
holes to insert bolts in door frame. Now tighten frame bolts starting at center and working
toward top and bottom on each side.
5. Keep inner panels (Q, R and S) latched and loosen all bearing pin bolts. Re-tighten all bearing pin
bolts. This makes loading on pins uniform for easier operation of panels.
6. If some latch bars are loose or require excessive force to lock, loosen hex socket cap screws and
adjust in or out until latch bars operate smoothly. Check that the panels are fully seated over all
bearing pins.
7. Re-install outer door cover (A). Adjust outer door hinges (C) and latches (B) as required.
8. Assemble door hold back (V and W) as shown. Open door cover (A) until it approaches the bin wall.
Hook the retaining bracket over lower latch mount and position the door hold back bracket against
bin wall in a valley. Drill a 3/8 in. hole through the bin wall and bolt the door hold back bracket to the
bin. If needed, install the door hold back extension to door hold back bracket.
134
PNEG-4936
36 Ft. TopDry Autoflow
Summary of Contents for TopDry Autoflow
