GSi Smart Climate 310, User Manual

Page: 60 / 102

60 Smart Climate 310 rev. 03
6. Press Adjust once again. The stop temperature
flashes on the display.
7. Set it to the desired value using the arrow keys.
8. Press
Adjust to validate.
9. Proceed in similar fashion to set the start and stop
temperatures of all heating stages.
Adjusting the Timer for Heater Stages
Heating stages can run in timer mode. This section shows how to
set this timer. The On and Off times can be adjusted from 0 to 15
minutes, in increments of 15 seconds. Refer to the User Setup
section of this manual to enable the heating stages' timer.
To adjust the timer for the heater stages, proceed as follows:
1. Press Heaters . The start temperature of the first timer
of heating stage 1 is displayed.
Accessible if the heating stage timer option is enabled in the USER
SETUP.
2. Press Adjust . The start temperature of the first timer
of heating stage 1 flashes on the display.
3. Use the arrow keys to set it to the desired value.
4. Press
Adjust to validate.
5. Press the down-arrow key. The stop temperature of
the first timer of heating stage 1 flashes on the display.
6. Use the arrow keys to set it to the desired value.
7. Press
Adjust to validate.
8. Press the down-arrow key once again. The On and Off
times of the first timer are displayed.
9. Press Adjust . The On time flashes on the display.
10. Use the arrow keys to set it to the desired value.
11. Press
Adjust once again. The Off time flashes on the
display.
12. Use the arrow keys to set it to the desired value.
13. Press the down-arrow key once again. The start
temperature of the second timer of heating stage 1 is
displayed.