28 Smart Climate 310 rev. 03
NOTE:
All ten points of the curve must be specified. If ten
points are not needed, repeat the last temperature value for
each unnecessary point.
NOTE
: The highest possible day number is 365. Decreasing
day numbers is not allowed.
The temperature offset allowed between two consecutive days
is +/-50°F (10°C)
Specifying the Curve
1. Press
Set Point / Curve
.
2. Press the down-arrow key to select the first point of the
curve. The day at which this curve point starts being used
and the set point for that day are displayed.
Accessible if the set point curve is enabled in the USER SETUP.
3. Press
Adjust
then use the arrow keys to select the day
and temperature set point that are associated with the first
curve step.
4. Press the down-arrow key to display and adjust all steps of
the curve.
Activating the Temperature Curve
Once the curve is configured, it must be activated.
1. Press
Set Point / Curve
.
2. Press the down-arrow key to select the curve status.
Accessible if the set point curve is enabled in the USER SETUP.
3. Press
ADJUST
. The curve status flashes on the display.
4. Use the arrow keys to enable or to disable the curve.
5. Press
ADJUST
once again to validate.
NOTE:
The controller automatically sets the day number back
to -5 days when the user activates the temperature curve.
Summary of Contents for Smart Climate 310
