Model G0853 (Mfd. Since 07/18)
-95-
Squaring the crosscut fence to the blade ensures
that cuts made with the crosscut fence will be
square. This procedure can be done by using a
32" x 32" piece of scrap plywood as a test piece
and making five test cuts, then adjusting the fence
as necessary.
Note: Getting accurate results with this procedure
is a matter of trial-and-error and patience.
To square crosscut fence with blade:
1. Make sure sliding table is parallel with
main blade (refer to
Sliding Table Parallel
Adjustment on Page 94 for detailed
instructions).
2. Release latch on 0° stop block and loosen
crosscut fence pivot lock knob (see
Figure
190) to allow fence to pivot.
Squaring Crosscut
Fence to Blade
Test
Piece
1
2
3
4
Figure 192. Fence adjustment test piece.
4. Prepare scrap test piece by cutting it to 32"
x 32" square, then number all four sides 1–4
(see
Figure 192).
Figure 190. Stop block against 0° stop bolt.
Pivot
Lock Knob
0° Stop Bolt
& Block
3. Move crosscut fence stop block against 0°
stop bolt (see
Figure 191), then retighten
pivot lock knob to secure fence in place.
5. Use crosscut fence to cut
1
⁄
2
" off of each side
of test piece, then cut side 1 again (make five
cuts total).
Figure 191. Stop bolt latch in secured position.
Stop Bolt
Latch
0° Stop Block
Summary of Contents for G0853
Page 24: ...22 Model G0853 Mfd Since 07 18 5mm Hardware Recognition Chart...
Page 140: ......
