Model G0853 (Mfd. Since 07/18)
-29-
4. Remove access covers to reach mounting
holes for sliding table (see
Figures 22–23).
Reach through cabinet access hole to reach
middle mounting hole (see
Figure 24).
5. Use (5) M12-1.75 x 50 hex bolts, 12mm lock
washers, and 12mm spacers to secure slid-
ing table to machine frame (see
Figures
22–24).
7. Attach cabinet door by sliding hinge sleeves
over pins on pre-installed hinges (see
Figure
26).
Figure 26. Cabinet door attached to hinges.
Hinge Sleeves
& Pins
Figure 25. Push handle attached to sliding table.
Push Handle
Knob
6. Slide push handle onto mounting rod at front
end of sliding table, as shown in
Figure 25,
and secure with knob.
Figure 23. Mounting hole access on rear side at
back of saw.
x 2
Figure 22. Mounting hole access on rear side at
front of saw.
x 2
Figure 24. Middle mounting hole access through
cabinet access hole.
Summary of Contents for G0853
Page 24: ...22 Model G0853 Mfd Since 07 18 5mm Hardware Recognition Chart...
Page 140: ......
