-30-
Model G0853 (Mfd. Since 07/18)
9. Attach large extension table to cast-iron table
using (3) pre-installed M10-1.5 x 25 cap
screws, 10mm lock washers, and 10mm flat
washers (see
Figure 27). Only hand-tighten
cap screws for now. They will be fully tight-
ened in a later step.
10. Place a straightedge across cast-iron table
and large extension table to see if tables are
parallel.
— If entire length of straight edge is parallel
with both tables, proceed to
Step 11.
— If both tables are not parallel with straight
edge,
loosen hex nuts on set screws
shown in
Figure 27. Adjust set screws to
align top of extension table with top of cast
iron table, then retighten hex nuts to secure
setting.
11. Fully tighten cap screws from Step 9.
12. Attach leg (see Figure 28) to large extension
table using (2) pre-installed cap screws, lock
washers, and flat washers.
13. Loosen hex nut on foot (see Figure 28),
adjust height of foot to maintain parallel-
ism of extension table and cast-iron table,
then tighten hex nut against bottom of leg to
secure.
15. Attach small extension table to cast-iron
table using (3) pre-installed M10-1.5 x 25 cap
screws, 10mm lock washers, and 10mm flat
washers (see
Figure 29). Only hand-tighten
cap screws for now. They will be fully tight-
ened in a later step.
Figure 28. Leg attached to large extension table.
x 2
Foot
Leg
8. Install (3) M10-1.5 x 20 set screws and (3)
M10-1.5 hex nuts on large extension table
(see
Figure 27). Only hand-tighten screws
for now.
Figure 27. Location of fasteners used to install
and level large extension table.
x 3
Hex Nut
Set Screw
x 3
14. Install (3) M10-1.5 x 20 set screws and (3)
M10-1.5 hex nuts on small extension table
(see
Figure 29). Only hand-tighten screws
for now.
Figure 29. Location of fasteners used to install
and level small extension table.
x 3
Hex Nut
Set Screw
x 3
Summary of Contents for G0853
Page 24: ...22 Model G0853 Mfd Since 07 18 5mm Hardware Recognition Chart...
Page 140: ......
